Aurender ACS100 Manual



Please read the following instructions carefully before setting up the Aurender Music Player.
• Be careful not to drop the device to avoid internal damage.
• Do not disassemble the device.
• Keep magnetic materials away from Aurender to prevent any damage to data.
• Do not expose device to oil, dust, water, high humidity, or smoke.
• Keep ventilation openings free from obstruction.
• When cleaning, use only a soft cloth. Keep out of contact with water or other liquids.
• All servicing must be performed by a qualified representative, or the warranty will be voided.
• Unplug power cord during severe lightning storms or when unused for a long period of time.
• Unplug the device from the outlet only after completely turning off the unit.
• Always turn the power off before connecting or disconnecting any cables.
• Please note that hard drives can break down.
It is important to back up your music collection periodically to a separate memory device. In the event of drive failure, Aurender is not responsible for any loss of data. The drive manufacturer will only replace faulty drives under warranty and do not compensate for any loss of data.



• Place your device on a flat, horizontal, and stable surface.
• Keep away from heat sources, such as radiators.
• Do not stack other products on top of the Aurender.
• Allow space around the device for ventilation.
• Do not place inside an enclosed cabinet.


Front Panel

1. On/Off/Standby

In the default mode, pressing will power the unit on and completely off. In the Standby mode, pressing the front panel button will put the unit into standby, and the unit will turn on instantly. In standby mode, to turn the unit completely, press the button once so that it shows the display and press the button again so that it turns off. Flashing will stop when the unit is off.

2. CD-ROM Slot

CD-ROM Slot. It is used to place a CD after ejected.

3. CD-ROM manual eject hole

When CD-ROM Eject button would not work, a pod with the length of 5cm (1.5inch) can be plugged in to eject CD-Tray manually

4-6 Display Menu

Display Menu 4~6 – It is assigned many features by the software.
Appropriate icon will be displayed besides the button.

7. Eject

Eject button for CD-ROM.
When the CD-ROM is closed, if pressed, CD-ROM tray will be ejected. When pressed again, CD-ROM tray will be closed.

8. USB 3.0 Port

Some supported USB 3.0 compatible devices like USB thumb drive can be used.
USB 3.0 external HDD can be attached to the port and used to transfer content faster than USB 2.0.

Rear Panel

1. LAN Port from home network

It is used to connect the unit to the local network.

2. USB 3.0 port

Some supported USB 3.0 device can be connected and used.
USB 3.0 external HDD can be attached to the port and used to transfer content faster than USB 2.0.

3. USB 2.0 port

Some supported USB 2.0 devices can be connected and used.

4. User Slot 1

User can open the product’s shutter and install SSD/HDD.

5. User Slot 2

User can open the product’s shutter and install SSD/HDD.

6. DC Power Switch

To turn off the unit completely

7. DC-Socket

Connect to AC Power adapter.



Before connecting audio cables, first check to see that all devices are grounded using grounded plugs and grounded sockets. In addition, all devices should be turned off, before connecting any audio or digital cables. If the devices are not grounded, a voltage potential difference between devices can cause a voltage surge through the audio cable that can weaken and eventually damage sensitive circuits in D/A converters and other devices.